Posted in Sewing
Rocketeer Feed Dog Cover Repair
Someone posted to one of my mailing lists that they were having trouble removing their feed dog cover plate because the lever wouldn’t move all the way, and the plate didn’t lift sufficiently to remove the plate. I’m having the same issue with Ada, as well as an intermittent power issue, *and* she needed an oiling, so I decided to give her some love and take some photos of the feed dog issue.
This is the lifter for the feed dog cover on the 500 series. It’s all the way across the body of the machine from the feed dogs:
When you do this:
It’s supposed to do this:
The posts that hold the feed dog cover plate are up, and there should be sufficient clearance to remove the plate. There is also a middle position in which the plate is high enough to keep the dogs from engaging with the fabric. In practice I don’t find the middle position functions as designed; Ada doesn’t make stitches when I raise the plate, and this is a common complaint on these machines. Not the problem I want to address today, however.
The issue, which may or may not be apparent, is that the posts don’t lift high enough to allow the plate to be removed. When I switch from the straight stitch plate to the zigzag I have to remove the needle and turn the hand crank to where the feed dogs are at their lowest and then jiggle and wiggle and curse a little to get it out. Annoying. So I’m fixing it.
First, I removed the cover plate and two lower plates for the lever:
There was some lint and no lubrication, but generally things looked fine. I didn’t expect the lever to be the source of the problem since mine would move to all the way to the left, so I flipped the machine up to examine her underbelly. Here is where the lever passes through the case:
There is a looooong bar across the machine to the bottom of the feed dog posts.
Here are some close ups:
They should get elevated by the bar pressing on springs when the lever is moved to the left, but mine were reluctant to budge much.
At this point there are two possibilities that occurred to me. Either it’s a lubrication problem, or the springs are dead. I can’t fix the latter, so I decided to address the former. I set the machine back into the surface of the table, and started lubricating.
First I lubed and reassembled the lever.
BE VERY CAREFUL replacing the screws. The lever makes it challenging to align the screws with the holes without binding the screws, and potentially damaging the threads. I found it was easiest to set the screws if I pulled the lever up and to the left.
(No shots of the reassembly. I guess I was cursing too much to think about it.)
Next I started lubing the posts.
I added a drip of oil, wiggled the lever a bunch, added more oil, wiggled the lever more, and kept doing that. Eventually yucky brown oil started coming back out of the hole where I was putting clean clear oil. I wiped the icky stuff off and kept applying until the lever moved smoothly and the oil coming back up was clean.
I found it easiest to apply the oil effectively when the posts were raised, not when they were lowered as in the pictures. That way I could get a drip on the back of the post and carry it down into the channel. I didn’t get any good pictures of the ick at its worst, but you can see some on the edges here:
Once the oil was nice and clear and the posts were moving more freely I replaced the feed dog cover plate, and it slipped into place nicely. I’ll keep after the lubrication for a couple weeks, but I’m hoping that’s all that was wrong.
Ada also appreciated getting lubed, and I’m appreciating the light staying on without having to jiggle the plug. There was a loose connection, but nothing a pair of pliers and a little electric tape couldn’t solve.